| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Intake/Exhaust | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000031GQ004X |
| Title: 3UR-FE INTAKE / EXHAUST: INTAKE MANIFOLD: REMOVAL (2008 Sequoia) | ||
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE V-BANK COVER SUB-ASSEMBLY
(a) Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
3. REMOVE AIR CLEANER HOSE ASSEMBLY
(a) Disconnect the vacuum hose and ventilation hose.
(b) Loosen the 2 clamps.
(c) Remove the air cleaner hose.
4. DISCONNECT VENTILATION HOSE ASSEMBLY
|
(a) Disconnect the ventilation hose from the ventilation pipe of the cylinder head cover LH and RH. |
5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
(a) Remove the No. 1 engine cover sub-assembly.
6. REMOVE NO. 3 ENGINE COVER
(a) Remove the No. 3 engine cover.
7. REMOVE INTAKE MANIFOLD
|
(a) Disconnect the 2 water by-pass hoses. |
(b) Disconnect the throttle W/ motor body connector.
|
(c) Disconnect the ventilation hose. |
|
(d) Disconnect the vacuum switching valve connector. |
(e) Disconnect the purge line hose from the No. 1 vacuum switching valve assembly.
(f) Disconnect the vacuum switching valve connector (for ACIS).
|
(g) Remove the 2 bolts. |
(h) Disconnect the No. 1 tube from the union to connector tube hose, and move the hose aside.
|
(i) Disconnect the 3 wire clamps from the 3 wire harness clamp brackets. |
|
(j) Remove the bolt and wire harness clamp bracket from the intake manifold. |
|
(k) Remove the 2 nuts, 8 bolts, intake manifold and 2 gaskets. |
8. REMOVE VENTILATION HOSE ASSEMBLY
|
(a) Remove the 2 bolts and ventilation hose from the intake manifold. |
9. REMOVE NO. 1 V-BANK COVER BRACKET
|
(a) Remove the 2 bolts and bracket. |
10. REMOVE V-BANK COVER BOLT
|
(a) Remove the 2 bolts from the intake manifold. |
11. REMOVE THROTTLE W/MOTOR BODY ASSEMBLY
|
(a) Remove the 4 bolts, throttle W/ motor body and gasket. |
12. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
|
(a) Disconnect the 2 vacuum hoses from the vacuum switching valve. |
(b) Remove the bolt and vacuum switching valve.
13. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
|
(a) Disconnect the purge line hose from the intake manifold. |
(b) Remove the bolt and No. 1 vacuum switching valve assembly.
14. REMOVE UNION TO CONNECTOR TUBE HOSE
(a) Remove the tube hose from the intake manifold.
15. REMOVE WIRE HARNESS CLAMP BRACKET
(a) Remove the 2 bolts and 2 wire harness clamp brackets.
|
|